Cornbread Croutons Recipe (2024)

FAQs

What ingredient keeps cornbread from crumbling? ›

Adding about 1 tablespoon (15 ml) of extra butter or vegetable oil can increase the moistness of your cornbread. You can do this even if your recipe doesn't call for butter or oil. Replace milk or water with creamed corn. If your recipe calls for milk or water, try replacing it with creamed corn.

generally speaking, cornbread is crumbly if there is too high a proportion of cornmeal to flour. you need the gluten in the flour to hold it together and also enough moisture.

Eggs, or egg substitutes help add structure to the cornbread. Without an egg or substitute, the cornbread may crumble and fall apart easily.

1Preheat the oven to 400°F (204°C). We recommend allowing cornbread batter to sit for 10 to 15 minutes before baking, so if you prefer, you can delay heating the oven until you make the batter. 2Melt the butter, and then set aside to cool slightly.

To achieve the crispiest golden crust on your cornbread, Delk Adams instructs you to grease the skillet liberally with bacon grease (if you don't have that, shortening, butter, or oil will do), then pop it into the hot oven for 5 minutes before pouring the batter in.

The batter should be thick, but still pourable. Add more milk or buttermilk if necessary. Remove the skillet from the oven and tilt the pan so the butter coats the bottom and sides of pan.

While not a professional chef, my experience with corn bread, be it packaged or made from scratch is if you over mix it, it's gonna fall! Also, let it sit for 4-5 minutes after gently scraping it into the pan and let the ingredients start their magic reactions. No peeking while baking!! That can make it fall too.

You can just use water instead which is what most cornbread mixes ask for in the first. I've used both before and it normally turns out good either way. If you don't want to use water though some other milk substitutes are usually other dairy products like yogurt, sour cream, or half and half.

Thoroughly grease a 9 x 9-inch baking dish. Sift together the flour, cornmeal, baking powder, and salt. Combine the half-and-half, eggs, butter (or shortening), and sugar (if using). Add half-and-half mixture to the flour mixture and combine just until the flour is moistened, no more than 10 to 15 seconds.

Just follow 2 & 2 & 2 rule and you'll have cornbread.” So the definition of “2 & 2 & 2” is: 2 eggs, 2 cups cornmeal (self-rising), and 2 cups buttermilk. Fast forward to 2018 after many, many pans of cornbread later and I can honestly say, I still rely on her rule, with a few additions.

How long can you let cornbread batter sit before baking? ›

In a medium bowl, using a wooden spoon, stir the corn flour and cornmeal with the buttermilk until there are no dry pockets remaining. Cover and refrigerate overnight (or for as little as 1 hour if you want to make the cornbread right now). Preheat the oven to 375°F.

LET the batter sit for 15-20 minutes before baking. This allows the baking powder to activate and incorporate more air.

Pour batter into prepared pan. The batter will be lumpy. Overcome the urge to mix until smooth. Overmixing can cause the corn bread to peak and have tunnels, resulting in a tough texture.

Why is my cornbread dense? If you overmixed your batter or over-measured your flour, your buttermilk cornbread could turn out dense. Be gentle with your batter and make sure you know how to properly measure flour.

It has a grainy texture, courtesy of stone-milled cornmeal from Anson Mills, where each bite is loaded with maximum impact. In other words, paying attention to your cornmeal pays off.

The Best Way to Store Muffins

Let them cool for no more than five-to-10 minutes in the pan, then transfer them to a wire rack to finish cooling completely. STEP TWO: Line an airtight storage container with paper towels. The paper towels will act like a “sponge,” absorbing the moisture the muffins emit as they age.

This happens when the grease is not kept hot enough throughout the frying process. Can also happen if the cornbread is moved before getting a crispy outer shell or that outer shell is broken from moving the cornbread around. The cornbread falls apart in the grease.